Cast Aluminium Pluse Solenoid Diaphragh Valve

A cast aluminum pulse solenoid diaphragm valve is a specific type of solenoid valve designed for controlling the flow of fluids or gases in pneumatic systems. These valves are commonly used in various industrial applications.
RCA20T DN20 Right Angle Pluse Solenoid Diaphragh Valve For Pulse Jet Dust Collector

RCA20T Pluse Solenoid Diaphragh Valve

1. The working pressure of the product is 0.1MPa~0.7MPa, and the medium is air that has been degreasing and dewatering.

2. When the working voltage of the solenoid valve is 85% of the rated voltage under the nominal air pressure of the product, the opening response time of the solenoid pulse valve should be less than 0.03s.

3. When the working air source pressure is 0.1MPa, the pulse valve can be closed.

4. The product should be able to withstand the gas source pressure of 0.8MPa.

5. Under the specified environmental conditions, the insulation resistance of the electromagnetic coil to the shell should be greater than 1MΩ.

6. Under the condition that the room temperature is 5 degrees to 35 degrees, and the relative humidity does not exceed 85%, the electromagnetic coil can withstand the voltage of 50Hz and 250V to the shell, and there is no breakdown phenomenon for 1min.

7. The electromagnetic pulse valve should be able to work normally after being subjected to vibration with a frequency of 20Hz, a full amplitude of 2mm and a duration of 30min.

8. Under normal conditions of use, the cumulative service life of the diaphragm should be greater than 800,000 times.

9. There is no obvious coating peeling, scratches, burrs and other damages on the surface of the valve.

10. The supply air pressure of the large-diameter ultra-low pressure electromagnetic pulse valve for rotary blowing is less than 0.1Mpa, and the compressed air is used, which is not affected by the simultaneous gas consumption of the pipe network, and the operation is stable and reliable. (0.05~0.1Mpa)