Correct handling method of air source processor

The air source processor is a device used to filter the moisture and oil in the compressed air. It only needs to be connected in series to the compressed air pipeline during use. After using for a period of time, the drain hole at the bottom of the oil water tank under the air source processor should be opened to allow the oil and water collected in it to drain. When in use, it only needs to be connected in series to the compressed air pipeline. After using for a period of time, the drain hole at the bottom of the oil water tank under the air source processor should be opened to allow the oil and water collected in it to drain.

At the same time, the more important point is that the air source processor should always check the operation of various pneumatic components, and check whether the connection fastening screws are loose? Is there any damage or leakage at the seal of the component? If problems are found, deal with them promptly; during maintenance, be sure to turn off the air source in advance and empty the compressed air in the pipeline system before performing maintenance operations to prevent accidents. The above is a brief analysis of some relevant analysis process of the gas source processor.