Cylinder exhaust port and guiding accuracy
Aug 19, 2019
Cylinder exhaust port and guiding accuracy
In the process of working, the cylinder can effectively determine the tension and thrust on the piston rod according to the required force, so that when the cylinder is selected, the output force of the cylinder should be slightly reserved, if the cylinder diameter is small. The output is so insufficient that the product will not work properly.
The cylinder diameter of the cylinder is too large, which not only makes the equipment more cumbersome and high in cost, but also increases the air consumption during the use of the device, which will cause waste of energy. In the process of fixture design, it should be as far as possible Adopt force-enhancing mechanism.
The inner diameter of the cylinder cylinder represents the output force of the cylinder to a certain extent. The piston should make a smooth reciprocating sliding in the cylinder, and the surface roughness of the inner surface of the cylinder should reach Ra0.8μm.
An exhaust port is effectively provided on the end cover of the cylinder, and some products are also provided with a buffer mechanism in the end cover, and a sealing ring and a dust ring are effectively disposed on the rod side end cover, so that To a certain extent, it effectively prevents the piston rod from leaking outward and prevents external dust from entering the cylinder.
The guide sleeve is effectively provided on the rod side end cover of the cylinder, so that the guiding precision of the product can be effectively improved to a certain extent, and a small amount of lateral load on the piston rod can be withstood during use, and the piston is reduced to some extent. The amount of bend when the rod is extended.
The piston is a part of the cylinder that is under pressure. In the process of use, the piston is effectively prevented from suffocating the left and right chambers of the piston. In the process of use, a piston sealing ring is provided, and the wear ring on the piston can effectively raise the cylinder. The guiding effect reduces the wear of the piston seal and reduces the frictional resistance.






