DMC pulse bag filter

Jan 08, 2020

DMC pulse bag filter

 

On the basis of absorbing the original pulse bag filter, the DMC pulse bag filter improves the original discharge system and simplifies the new single-machine dust removal unit with the equipment structure. It has the advantages of large processing capacity, good purification effect, convenient operation and maintenance, low working noise, long service life of filter bag and no mechanical moving parts.

 

Equipment introduction

DMC pulse bag filter is absorbed in the original DMCC pulse bag filter, on the basis of original discharging system was improved and simplified the device of the structure of the new type of single dust removal unit, the improved equipment, with large processing capacity, good purification effect of the characteristics of convenient operation and maintenance, compared with the mechanical vibration warehouse top precipitator work also has low noise, long service life of filter pocket, no mechanical wear parts, etc, applicable to all kinds of powder on top of the repository, is used to capture all kinds of fine, dry the fibrous dust.

 

The working principle of

Central dust by under the dust into the air filter box, coarser particles of dust by its own gravity settling down after the fall into the ash bin, tiny dust through a variety of effects by adsorption on the outside of the filter bag, the filter bag in the purification of the filtered air through the venturi tube from the outlet discharge into the enclosure, the adsorption on the outside of the filter bag dust as the growth of the time, more product more thick, filter resistance increasing, the amount of gas processing. In order to keep the dust collector in an effective working state and keep the pressure loss in a certain range, it is necessary to remove the accumulated dust adsorbed on the outside of the bag wall. 

 

Soot cleaning process is prescribed by the controller according to the requirements of various electromagnetic pulse valve issue instructions, and in turn open the valve, in order to each injection of high pressure air bag, so the air bags in the compressed air through the hole of spray torch through the venturi tube into the filter bag (referred to as a wind), and when the injection in the high speed air flow through the venturi tube, ejector of instant, several times in a wind around air is induced into the bag at the same time (called a secondary air). As a result of this, the formation of the secondary wind and the filter flow of a strong reverse airflow into the bag, so that the filter bag in a moment of sharp contraction - expansion - contraction, and the reverse effect of the airflow, will be adsorbed in the outside of the bag wall to remove the dust.

 


Considerations for type selection

 

In the selection of DMC pulse bag filter, attention should be paid to the dust concentration at the inlet. In terms of technical performance, the airflow velocity of the filter bag (that is, the filtration wind speed) is inversely proportional to the dust concentration of the gas. Therefore, when determining the filtration area, the dust accumulation capacity of the filter bag (i.e. the maximum allowable dust accumulation per unit area of the filter bag during the two dedusting periods) should also be met. Generally speaking, the dust accumulation capacity is no more than 400g/㎡, which can also be calculated as follows, i.e

 

Dust accumulation capacity = dust concentration of inlet gas × filtration wind speed × interval time between two cleaning

 

If the calculated results exceed the dust accumulation capacity, the filter wind speed should be adjusted to increase the filter area.