Pneumatic winch
Nov 01, 2019
Pneumatic winch
The pneumatic winch is powered by a vane air motor, which transmits power to the drum to lift heavy objects through a planetary gear reducer.
product manual
The pneumatic winch motor and the reducer are respectively connected to the two sides of the drum, so that the winch is small in size, light in weight, compact in structure, simple in operation, convenient in maintenance, and can realize stepless speed regulation within a certain range, and the brake of the winch is braked by the motor. Realized, the brakes are reliable. Manual operation is possible without compressed air.
Precautions for use
1. First the pneumatic motor, then the transmission gear starts to run. Before starting, the brake band on the reel should be braked first, and the brake lever on the large gear should be released, so that the reel does not rotate, only the large internal gear rotates.
2. If you want to start the reel, you must first completely loosen the brake band on the reel and then brake the brake band on the large internal gear. At this time, the reel is rotated and wound around the wire rope to work.
3. In the working process of the pneumatic winch, if the pneumatic winch is to be suspended, the brake band of the large internal gear can be loosened, and then the brake band on the reel can be braked.
4. When starting the electric vehicle, the two brakes cannot be braked at the same time, otherwise the motor will be burnt.
5. The temperature of the drum brake belt and bearing of the pneumatic winch cannot exceed 70 °C. If the temperature rises drastically, it must be stopped immediately.
Operation and maintenance
1. Do not arbitrarily remove the parts of the tool and operate it. In addition to affecting the safety of the author, the tool may be damaged.
2. If the tool is slightly faulty or cannot be used until the original function is used, it can no longer be used. Check it immediately. Regularly (about once a week) Check and maintain tools, add grease (Grease) to the rotating parts such as bearings, and add oil (Oil) to the air motor.
3. Use all kinds of tools, be sure to follow the various safety regulations and instructions for use.
4, to use the appropriate tools to work, the tool is too large to cause work damage, too small tools can easily cause damage to the tool.
5. The inlet pressure is at the inlet of the tool (the outlet pressure of the non-air compressor) is generally 90PSIG (6.2Kg/cm^2). Too high or too low will damage the performance and life of the tool.






