SC pneumatic cylinder mounting

Various mounting accessories of SC cylinder are listed:

List of cylinder installation accessories

1. Front and rear flange installation accessories:

The front flange type uses flange and screw to fix the air cylinder at the front end cover, and uses blue plate to separate, which can reduce the load borne by four pull rods, and is suitable for the occasions where the load movement direction is consistent with the axis of the piston rod.

2. Base mounting foot stand type accessories:

It is indicated by LB that an L-shaped mounting foot is used to install and fix with screws at the screw holes of the front end cover. The mounting foot can bear a large overturning moment and can be used in the situation where the load movement direction is consistent with the axis of the piston rod.

3. Rear Single earring installation type:

It refers to a cylinder with a pin hole in the vertical direction of the axis of the piston rod. The load and cylinder can swing around the pin shaft. The greater the swing angle, the greater the transverse load on the piston rod.

4. Intermediate shaft pin support and installation type:

It refers to the installation and fixation of the cylinder by swinging TC in the middle of the cylinder. The cylinder of this installation mode can swing around the middle trunnion, which is suitable for long cylinder.