Use and Advantage of Cylinder Seal Ring

Sep 17, 2019

The use and advantages of these sealing rings are introduced by Smart-Pneumatic below.


1. O-ring


The O-ring seal is reliable, simple in structure and low in frictional resistance.


After the O-ring is installed, the inner diameter or outer diameter of the sealing surface should be greater than or less than 0.15-0.6 mm, respectively. If the pre-contraction compression is too large, the friction resistance will increase.


2. L-shaped sealing ring


L-ring seals are reliable, long service life and larger friction resistance than O-ring seals. Usually used for cylinders larger than 100mm in diameter.


When assembling, the screw should not be tightened too tightly to avoid deformation and damage the sealing performance.


3. Y-ring


Y-ring seals are reliable, have long service life and larger friction resistance than O-ring seals. Usually used for cylinders larger than 100mm in diameter.


4. Small Y-ring


Small Y-ring seals have high wear resistance and oil resistance, high strength and good elasticity. Its service life is several times longer than that of oil-resistant rubber seals. The friction force is much smaller than that of O-shaped and Y-shaped.


The piston structure is simple, and the length-width ratio of the sealing ring section is larger than 2. The sealing ring will not roll down in use, and has good self-sealing performance, and will not leak at low pressure.