What are the advantages of air source processor?

The filtration degree is generally 50-75 μ m. The regulating range is 0.5-10mpa. If necessary, the filtering accuracy is 5-10 μ m，10-20 μ m，25-40 μ m. The components with pressure regulation of 0.05-0.3mpa and 0.05-1mpa are called triplets. The three parts are indispensable air source devices in most pneumatic systems. They are installed near the gas equipment, which is the post guarantee of compressed air quality. The installation sequence of the three parts is air filter, pressure reducing valve and oil mist device according to the air inlet direction.

The combination of air filter and pressure reducing valve can be called pneumatic two-piece. The air filter and pressure reducing valve can also be assembled together to become a filter pressure reducing valve (the function is the same as that of the air filter and pressure reducing valve). In some cases, the oil mist in the compressed air can not be allowed, so the oil mist separator should be used to filter out the oil mist in the compressed air.

In short, these components can be selected according to the needs, and they can be combined for use. The air filter is used to clean the air source, which can filter the moisture in the compressed air to avoid the moisture entering the device with the gas.

The pressure reducing valve can stabilize the gas source and keep the gas source in a constant state, which can reduce the damage to the valve or actuator due to the sudden change of gas pressure.

The filter is used to clean the air source, which can filter the water in the compressed air to avoid the water entering the device with the gas.

The oil mist device can lubricate the moving parts of the engine body and the parts that are inconvenient to add lubricating oil, thus greatly extending the service life of the engine body.

There are two ways of filter drainage: differential pressure drainage and manual drainage. During manual drainage, discharge before the water level reaches the level below the filter element.

When adjusting the pressure, before turning the knob, please pull it up first and then turn it. Press down the knob for positioning. Turn the knob to the right to increase the outlet pressure, and turn the knob to the left to decrease the outlet pressure. When adjusting the pressure, it should be gradually and evenly adjusted to the required pressure value, not in one step.

How to use the oil feeder: JIS k2233 oil (ISO vg32 or equivalent oil) is used for the oil feeder. Please don't fill more than 8% of the cup. The number 0 means small oil quantity and 9 means large oil quantity. It can't rotate from 9-0 position, it must rotate clockwise.