Working principle of rectangular electromagnetic pulse valve

The right angle electromagnetic pulse valve is a right angle valve, and the angle between the inlet and outlet is 90 degrees. It is suitable for the installation and connection of the air storage cylinder and the dust removal injection pipe. The air flow is smooth, and can provide the required pulse dust cleaning air flow.

Technical parameter

Working pressure: 0.3-0.6mpa working medium: clean air

Voltage: DC24 V / AC220 v current: 800 MA / 60 Ma

Use environment: temperature ℃ - 65 ℃, air relative humidity no more than 85%

Service life: 1 million times or 2-3 years

Working principle of rectangular electromagnetic pulse valve

The diaphragm divides the electromagnetic pulse valve into two chambers: the front chamber and the rear chamber. When the compressed air is connected, the compressed air enters the rear chamber through the throttle hole. At this time, the pressure of the rear chamber makes the diaphragm assembly close to the output port of the valve, and the electromagnetic pulse valve is in the "closed" state.

The electric signal of the pulse injection controller makes the armature of the electromagnetic pulse valve move backward, the vent hole of the air chamber behind the valve is opened, the pressure of the air chamber is rapidly lost, the diaphragm assembly moves backward, the compressed air is injected through the output port of the valve, and the electromagnetic pulse valve is in the "open" state.

When the electrical signal of the pulse injection controller disappears, the armature of the electromagnetic pulse valve is reset, the vent hole of the rear chamber is closed, and the pressure rise of the rear chamber makes the diaphragm assembly close to the output port of the valve, and the electromagnetic pulse valve is in the "closed" state.

DMF-Z right angle electromagnetic pulse valve is the compressed air "switch" of the dust cleaning and injection system of pulse bag filter. Controlled by the output signal of pulse injection controller, the filter bag is injected to clean the dust row by row (room) to keep the resistance of the dust collector within the set range, so as to ensure the treatment capacity and dust collection efficiency of the dust collector.