Die cutting and slitting principle of pneumatic stripping machine

Die cutting and slitting principle of pneumatic stripping machine

The working principle of the pneumatic stripping machine is that the motor at the front end is controlled by the PLC, and the motor is driven to mold the upper and lower die.

The average number of die-cutting is about 150-200 times per minute. It is assumed that according to the calculation of each model, eight hours per day, its production capacity is still properly reached. The key is that waste disposal has always been a headache for all die-cutting manufacturers. Therefore, each process instructor relies on the function of the machine to reduce the manual waste as much as possible, which results in a variety of processes and subsequent machine modifications.

Faced with many die-cutting collectives, die-cutting machine manufacturers will not consider the same week, in order to facilitate the user's use, as long as the modification and other strategies to complete the personalized and cost-effective slitter operation principle is more simple, simple can go through the machinery Processing factory to order.

A motor is equipped with a belt to drive the bearing, and the material of the loop is fixed to the bearing, and the cutting process is completed by the advancement of the number of knives. What is more messy is that the pneumatic stripping machine adds an inverter to control the operating speed of the motor on the basis of the original, plus a PLC to control the orientation of the cutter. The cutting principle is the same as the brother of the slitting machine. It is used to cut some materials that can't be cut by the slitting machine, especially some materials that have no backing glue and softer materials, such as thicker foam. The edge of the cutting edge is not easy to be unwound. Need to split the machine to cut.

Its working principle is to spread the rolled data, and the motor drives the front bearing to pull the spread information. In the traction process, there is a round knife with similar scissors between the bearing and the coil. The opened data is cut into one piece, so it is called the stripper machine with some sticky information, mainly refers to the double-sided tape and the adhesive protective film, which is applied to the release paper.

The main method is to cut the die. We all know that the adhesive tape with adhesive material is applied to the plastic paper in the plane, and in the process of rewinding, the crease of the paper and the rubber is different, which causes wrinkles.

Under normal circumstances, except that the data is particularly weak, and the paper is particularly good, it is generally not rewindable. Its mechanical principle is that after two bearings (one loaded with one paper) and the roller back pressure that can adjust the viewpoint, it is finally rewinded to complete the work. The viewpoint and positioning here are two important elements.