Precautions for installation and use of water solenoid valve

1. The anti explosion performance of solenoid valve for water is poor, so it can not be used in the occasion of explosibility.

2. Read the instruction manual before use, and it can be used only when it meets the use conditions of the solenoid valve.

3. The pressure resistance of the solenoid valve for water is not very strong, so in the process of use, traditional Chinese medicine detects the pressure of the pipeline to avoid danger caused by too much pressure.

4. The solenoid valve for water is not suitable for the medium with particle impurities. The pipeline should be kept clean as much as possible without dirt and impurities. At the same time, the dirt inside the solenoid valve should be cleaned regularly. It is better to equip a filtering device before the solenoid valve.

5. In the pipeline system, the diameter of the solenoid valve installed on the branch shall be smaller than that of the main pipeline valve

6. When the solenoid valve fails, in order to isolate the solenoid valve in time and ensure the normal operation of the system, it is better to install a bypass device.

7. In case of solenoid valve failure, in order to isolate the solenoid valve in time and ensure the normal operation of the system, it is better to install a bypass device.

8. The valve shall not be installed in the low concave part of the pipeline, so as to prevent the operation from being hindered by the deposition of steam condensate, impurities, etc. in the valve.

9. During installation, the solenoid valve coil shall be upward and kept in a vertical position. The arrow or mark on the solenoid valve shall be consistent with the flow direction of the pipeline, and shall not be installed in the place with splashing or water leakage.