Safety operation - installation instructions for solenoid valve
Dec 06, 2019
Safety operation - installation instructions for solenoid valve:
1. Carefully read the product manual before installation, check whether the product meets the use requirements, remember the key points of installation, and make preparations.
2. Check whether the parameters marked on the nameplate are consistent with those of the selected products. The power supply voltage shall meet the fluctuation range of rated voltage: AC + 10% ~ - 15%, DC + 10% ~ - 10%. At ordinary times, the coil assembly shall not be disassembled.
3. Before taking over the solenoid valve, flush the pipeline with a pressure of 0.3MPa, and remove the metal powder, sealing material residue, rust, etc. in the pipeline.
4. Pay attention to the cleanliness of the medium. If the medium is mixed with dust, impurities, etc., which hinder the normal operation of the solenoid valve, the pipeline shall be equipped with filter valve screen ≥ 60 mesh.
5. The solenoid valve should not be installed in the low concave part of the pipe, but in the discharge pipe of the container. It should not be led out from the bottom of the container, but should be installed at a slightly higher position at the bottom of the container.
6. If the medium will cause water hammer, the solenoid valve with water hammer prevention function shall be selected or corresponding preventive measures shall be taken.
7. The inlet side of solenoid valve for steam shall be equipped with drain valve, and the connecting pipe shall be inclined.
8. The solenoid valve is generally directional and cannot be installed reversely. Generally, the direction of medium flow shall be indicated by "→" on the valve body. During installation, the direction indicated by "→" shall be followed, except that the company may sometimes propose to install reversely in the vacuum pipeline or under special circumstances.
9. Installation position: generally, the solenoid components of the solenoid valve shall be vertically upward and vertically installed in the pipeline that is horizontal to the ground. If it is limited by space or the working condition requires that it must be installed according to the pipeline like the building sewer or upside down, please put forward when selecting and ordering. Some products have special regulations. Please install according to the instructions.
10. When connecting pipes, the sealing materials shall not be used excessively. In case of threaded connection, the nozzle thread shall be kept within the effective length, and chamfered with a file at the half pitch of the end, and the sealing tape shall be wound at the two teeth from the end, otherwise the excessive sealing tape or adhesive will enter the inner cavity of the solenoid valve, and the normal operation will be hindered.
11. There should be some reserved space at the installation of solenoid valve for daily maintenance and regular maintenance.
12. When installing, fix the valve body with spanner or pipe wrench, and then screw on the connecting pipe. Do not use the force on the solenoid coil assembly to cause deformation, so that the solenoid valve is difficult to work normally.
13. In case of insufficient pipe rigidity or water hammer, please fix the front and rear connecting pipes of the valve with brackets.
14. When it is used in frozen places, it is necessary to protect the pipes with heat insulation materials or set heaters on the pipes.
15. Confirm whether there is leakage at the solenoid valve itself and its connection with the connecting pipe.
16. Check the connection of coil outgoing line, especially in the case of three outgoing lines.
17. Electrical components connected to solenoid valve, such as relay, switch, contactor, etc. When opening the valve, the contact shall not vibrate, otherwise the operation will be unreliable and affect the service life of the solenoid valve.
18. The electrical circuit shall be connected to the corresponding fuse as the protection of the electrical circuit.






