Important Four Pneumatic Cylinder Working Environments

The cylinder is the actuator of the entire pneumatic system. The conversion of compressed air into mechanical energy output is an important guarantee for the operation of pneumatic components. Then, what should they pay attention to in their working environment, the basic point? The following cylinder manufacturers make a brief analysis:

Before using the loose connection points to check the mounting barrel, consider operating a safety interlock. When the sequence control should check the position of the working cylinder.

1, dust

When using Pneumatic Cylinder in a dusty environment, the dust cap should be placed on the piston rod. To install a single Pneumatic Cylinder hole breathing filter to prevent dust from inhaling the breathing holes.

2, lubrication

The required Pneumatic Cylinder Lubricating Oil is selected for the treatment of acyclic expansion and contraction, as well as moisture in the air and non-emulsified lubricating oil.

3, take over

The front Pneumatic Cylinder access pipe must be clear of the pipe inside the dirt to prevent debris from entering the Pneumatic Cylinder.

4, the ambient temperature

Typically, the Pneumatic Cylinder is at a predetermined operating temperature of 60 °C. In the case of CPneumatic Cylinders below 5°, it is sometimes disadvantageously affected by the condensation of moisture contained in the compressed air supplied to the Pneumatic Cylinder. At this point, the compressed air requirement qgbPneumatic Cylinder is lower than the ambient temperature of 5 ° C dew point temperature; to prevent condensation in the compressed air. Consider the type of sealing and lubrication at low temperatures.