Installation form of cylinder and magnetic switch

Installation form:

Basic type, foot type, rod side flange type, rod side flange type, single ear ring type, double ear ring type, rod side trunnion type, rod side trunnion type, central trunnion type

Buffer device of cylinder:

No buffer, rubber buffer, air buffer and hydraulic buffer

Magnetic switch

1) Installation form

2) It should be noted that only cylinders with magnetic rings should be paired with magnetic switches. Different cylinders and magnetic switches are also paired and cannot be matched casually. For example, pen cylinders are fixed with steel strips. The installation mode of magnetic switch shall be considered in the design to avoid position interference.

Other requirements:

For example, when the cylinder works in a harsh environment such as dust, it is necessary to design a dust cover at the protruding end of the piston rod. When no pollution is required (food industry, pharmaceutical industry, lithium battery industry), the cylinder without oil supply or oil lubrication shall be selected

In short, the steps of cylinder selection are generally divided into the following:

Selected cylinder diameter - selected cylinder stroke - selected cylinder series - selected installation form - selected buffer type - selected magnetic switch