Pneumatic angle seat valve selection points
Nov 07, 2019
The pneumatic angle seat valve has an advanced outer angle seat valve. There is a self-adjusting sealing cap between the overflow and the slide. Compared to conventional shut-off valves, the valve body of the angled seat structure allows for greater flow. The pneumatic angle valve is designed according to the characteristics of no flow resistance, no water hammer and large flow. Pneumatic angle valves are widely used in food, beverage, textile, printing and dyeing, pharmaceutical, chemical and machinery manufacturing industries.
When selecting a pneumatic angle seat, the following four points should be noted:
(1) fluid type, temperature, inlet pressure, pressure difference between inlet and outlet;
(2) The specifications of the pneumatic actuator shall be selected according to the pressure of the controlled compressed air;
(3) Action mode: single action, normally closed, double action, free state, etc., double action, normally closed;
(4) Select the matching specifications of the solenoid valve according to the action type: 2-position 3-way, 2-position 5-way, DC24V, AC220V; and detail the pneumatic angle seat valve: suitable for any inert gas or corrosive liquid and gaseous medium, using thread When the valve body is used, it should be noted that the e installation size is small enough and long. The connection of the control medium can be rotated 360 degree angle and has good flow characteristics. The pneumatic angle seat valve is widely used in short time and frequent start, and has the characteristics of sensitive response and accurate movement. Pneumatic control can control gases and liquids through the use of solenoid valves. Volume flow. Achievable temperature control and liquid dripping.






