About The Automatic Operation Of The Rodless Pneumatic Cylinder

Pneumatic Cylinder with high frequency action, the cylinder temperature is high, don't touch it. Rodless Pneumatic Cylinder stopped midway, pay attention to the possibility of accidents caused by the movement of air leakage. The driven object should be covered with a protective cover and cannot be in direct contact with the human body. When the rodless Pneumatic Cylinder is used for impact action, it is necessary to design a device in which the hand and foot are not caught between the driving member and the fixing member.

Air quality requirements

Use clean, dry compressed air. The air should not contain synthetic oil, salt, corrosive gas, etc. of the machine solvent, in order to prevent the cylinder and valve from malfunctioning. Before installation, the connection piping should be thoroughly purged. Do not bring impurities such as dust, chips, and sealed bags into the cylinder or valve.

About the lubrication of rodless Pneumatic Cylinder

Oil-lubricated rodless Pneumatic Cylinder should be equipped with a suitable flow mist. Pneumatic Cylinder is not lubricated with oil. It can be used for a long time because it is pre-filled with grease. This type of cylinder can also be used for oil, but once oil is supplied, it is no longer possible to stop the oil supply. Turbine oil No. 1 should be used for oil supply. Oil, spindle oil, etc. should not be used to prevent the NBR and other seals from swelling.

About the automatic operation of the rodless Pneumatic Cylinder

Automatically operated devices, in the mechanism or the circuit, must have countermeasures against personal and device damage caused by misoperation and disorder of the rodless Pneumatic Cylinder.

Long stroke rodless Pneumatic Cylinder

Rodless Pneumatic Cylinder should have adequate intermediate support when it exceeds the maximum standard stroke.

Rodless Pneumatic Cylinder for high speed motion

 The load rate should be reduced to reduce the impedance of the charge and discharge.