Two-axis Pneumatic Cylinder System Must Be Fitted With A One-way Throttle

When installing a two-axis Pneumatic Cylinder, the main two-axis Pneumatic Cylinder piston rod should not be subjected to eccentric load or lateral load. The load cloud top should be aligned with the piston rod axis. The long-stroke dual-axis Pneumatic Cylinder load and piston rod link should be used. Movable V-joint or joint. The twin-axis Pneumatic Cylinder mounting base must be sufficiently rigid, regardless of the type of installation.

The two-axis Pneumatic Cylinder with front and rear flange and tripod mounting should avoid the load of the mounting bolt directly bearing thrust or tension.

Two-axis Pneumatic Cylinder adjustment. When there is a certain requirement for the speed of the two-axis Pneumatic Cylinder movement, the two-axis Pneumatic Cylinder system must be equipped with a one-way throttle valve. In general, the two-axis Pneumatic Cylinder horizontally mounted exhaust throttle two-axis Pneumatic Cylinder is relatively stable. For the two-axis Pneumatic Cylinder vertical installation, the two-axis Pneumatic Cylinder should be connected to the load. The speed control valve should be adjusted to the middle of the adjustment range and then the output pressure of the pressure reducing valve should be adjusted. When the two-axis Pneumatic Cylinder is close to the speed When the speed is specified, it can be determined that the pressure is set and then the speed adjustment valve (one-way throttle valve) can be used for fine adjustment.