Reasons For Plastic Deformation Of Pneumatic Cylinder
May 26, 2019
Pneumatic Cylinder mainly converts the pressure of compressed gas into mechanical energy. When Pneumatic Cylinder is in operation, it can directly perform linear motion or complex swing operation.
1. During the process of repairing or installing, Pneumatic Cylinder may cause the expansion gap of the cylinder partition and the steam seal of the equipment to be inappropriate due to the technical maintenance or repair process, so that the product will appear after operation. The huge expansion force causes the Pneumatic Cylinder to deform.
2. During the operation of Pneumatic Cylinder, the force is complicated. In addition to the pressure difference between the internal and external gases, it is also subject to the static load of many other components. The reaction force of the stationary part and the force of the various hot and cold states of the connected pipe to the product.
3.Pneumatic Cylinder will generate some stress after the repair process in the process of machining, but it does not effectively eliminate the amount of tempering of the equipment, which will directly lead to the existence of relatively large residual stress inside the product. Then there is a permanent deformation during the running process.
